Fluke 1587/MDT 1587 MDT Advanced Motor And Drive Troubleshooting Kit

1587 Insulation Test
Minimum Test Current @ 1kΩ/V:	1mA
Test Voltages:	1577: 500, 1000 V 1587: 50, 100, 250, 500, 1000 V
Maximum Resistance per Test Voltage:	50V:   100V:   250V:   500V:   1000V: 1577: 600 MΩ   1587: 2 GΩ
Maximum Resolution per Test Voltage:	50V: 0.01 MΩ 100V: 0.01 MΩ 250V: 0.1 MΩ 500V: 0.1 MΩ 1000V: 0.1 MΩ
Accuracy per Test Voltage:	50V: (3 % + 5) 100V: (3 % + 5) 250V: (1.5 % + 5) 500V: 1577: (2.0 % + 5)   1587: (1.5 % + 5) 1000V: 1577: (2.0 % + 5)   1587: (1.5 % + 5) to 600 MΩ, (10 % + 3) above 600 MΩ

1587 Environmental Specifications
Operating temperature	20 C to +55 C
Storage temperature	-40C to +60C
Humidity (Without Condensation)	0% - 95% (10 C 30 C)   0% - 75% (30 C 40 C)   0% - 40% (40 C 55 C)
Operating Altitude	2000 m

1587 Safety Specifications
Overvoltage category	Complies with ANSI/ISA 82.02.01 (61010-1) 2004, CAN/CSA-C22.2 NO. 61010-1-04, and IEC/EN 61010-1 2nd Edition for measurement CAT III 1000 V and CAT IV 600 V
Agency Approvals	2000 m CAT III 1000 V, CAT IV 600 V; 3000 m CAT II 1000 V, CAT III 600 V

1587 Mechanical & General Specifications
Size	203 x 100 x 50 mm (with holster)
Weight	624 g
Warranty	3 years
Battery life Alkaline	Meter use: 1000 hours Insulation test use: Meter can perform at least 1000 insulation tests with fresh alkaline batteries at room temperature. These are standard tests of 1000 V into 1 MΩ with a duty cycle of 5 seconds on and 25 seconds off.
IP Rating	IP40

i400 Specifications
Nominal current range	400A
Continuous current range	1 A - 400 A
Maximum Non-Destructive Current	1000 A
Lowest measurable current	1 A
Basic accuracy	2% + 0.06 A    (45-400 Hz)    (% reading + floorspec)
Useable frequency	5 Hz - 20 kHz
Output level(s)	1 mA/A

i 400 Safety Specifications
Safety	CAT IV 600 V, CAT III, 1000 V
Maximum voltage	1000 V AC rms from earth to ground, in compliance with EN61010

i 400 Mechanical & General Specifications
Warranty	1 year
Maximum conductor diameter	32 mm (1.25 inches)
Maximum conductor size (busbar)	750 MCM
Output cable length	1.5 m (59 inches)
Shrouded banana plugs	Yes

Technical Specifications
Voltage range	40-700 V
Frequency range	15-400 Hz
Operating timer	Continuous

Environmental Specifications
Operating temperature	0 C to 40 C
Dust/water resistance	IP 40

Safety Specifications
Electrical Safety	EN 61010,    EN 61557-7
Overvoltage category	CAT III, 600 V    CAT IV, 300V

Mechanical & General Specifications
Size	124 x 61 x 27 mm
Weight	200 g
Power supply	From unit under test
Warranty	2 years